Super Crown

Made this after seeing all the comics about Bowsette.

The crown is made up of two pieces. The bottom can be worn as is. The top part fits nicely into the bottom piece. I was originally thinking that this top piece could be fitted with fabric stretched over, for an even more regal look.

It measures approximately 6.5 in x 6.5 in x 4.25 in. The base is 4.5 inches in diameter. It can be scaled up or down to fit pretty reliably. Don’t forget to use supports.

Just print it up and give it a royal paint job.

Get Super Crown 3D Model File

Leave a Reply

Your email address will not be published. Required fields are marked *

0